Air Bag Deactivation Switch: Service and Repair

Curtain Shield Airbag Cutoff Switch:

CURTAIN SHIELD AIRBAG CUTOFF SWITCH

REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected.

2. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)
3. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)
4. REMOVE COWL SIDE TRIM BOARD LH
5. REMOVE INSTRUMENT SIDE PANEL LH
6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH




7. REMOVE CURTAIN SHIELD AIRBAG CUTOFF SWITCH
a. Disconnect the connector.
b. Detach the 2 claws and remove the switch.

INSTALLATION




1. INSTALL CURTAIN SHIELD AIRBAG CUTOFF SWITCH
a. Attach the 2 claws to install the switch.
b. Connect the connector.

2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
3. INSTALL INSTRUMENT SIDE PANEL LH
4. INSTALL COWL SIDE TRIM BOARD LH
5. INSTALL FRONT DOOR SCUFF PLATE LH (for Double Cab)
6. INSTALL FRONT DOOR SCUFF PLATE LH (for Regular Cab)
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.

8. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.