Wiper Switch: Service and Repair

Wiper Switch:

WIPER SWITCH

REMOVAL

1. REMOVE LOWER STEERING COLUMN COVER
a. for Manual Tilt and Telescopic:
1. Operate the tilt and telescopic lever to fully extend and lower the steering column.

b. for Power Tilt and Telescopic:
1. Turn the ignition switch ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.




c. While turning the steering wheel to the right and left, remove the 2 screws and lower steering column cover.
d. Detach the 2 claws to remove the lower steering column cover.

NOTE: Do not damage the tilt and telescopic switch.




2. REMOVE UPPER STEERING COLUMN COVER
a. Detach the 4 clips.
b. Detach the claw to remove the upper steering column cover.




3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
a. Disconnect the 2 connectors.
b. Detach the claw and remove the wiper switch.

NOTE: Do not push the claw with excessive force as it may brake.

INSTALLATION




1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
a. Attach the claw to install the wiper switch.
b. Connect the 2 connectors.




2. INSTALL UPPER STEERING COLUMN COVER
a. Attach the 4 clips to install the upper steering column cover onto the instrument panel cluster finish panel.
b. Attach the claw to install the upper steering column cover.




3. INSTALL LOWER STEERING COLUMN COVER
a. Attach the 2 claws to install the lower steering column cover.

NOTE: Do not damage the tilt and telescopic switch.

b. Using a screwdriver, while turning the steering wheel to the right and left, install the 2 screws and lower steering column cover.