Crankshaft, Engine
CrankshaftThrust clearance
Standard 0.04 to 0.24 mm (0.00157 to 0.00945 in.)
Maximum 0.30 mm (0.0118 in.)
Crankshaft bearing cap set bolt tension
Portion diameter
Standard 10.0 to 10.2 mm (0.394 to 0.402 in.)
Circuit runout
Maximum 0.06 mm (0.00236 in.)
Main journal diameter 71.988 to 72.000 mm (2.8342 to 2.8346 in.)
Main journal taper and out-of-round
Maximum 0.02 mm (0.000787 in.)
Crank pin diameter 55.992 to 56.000 mm (2.2044 to 2.2047 in.)
Crank pin taper and out-of-round
Maximum 0.02 mm (0.000787 in.)
Oil clearance
Standard 0.018 to 0.030 mm (0.000709 to 0.00118 in.)
Maximum 0.046 mm (0.00181 in.)
Main journal bore diameter on cylinder block 77.000 to 77.016 mm (3.03149 to 3.03211 in.)
Standard bearing center wall thickness
Mark
1 2.488 to 2.491 mm (0.0980 to 0.0981 in.)
2 2.491 to 2.494 mm (0.0981 to 0.0982 in.)
3 2.494 to 2.497 mm (0.0982 to 0.0983 in.)
4 2.497 to 2.500 mm (0.0983 to 0.0984 in.)
5 2.500 to 2.503 mm (0.0984 to 0.0985 in.)
Drive plate and ring gear x Crankshaft 83 N*m (46 kgf*cm, 61 ft.*lbf)