ACC Cut Relay

ON-VEHICLE INSPECTION

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE ACC CUT RELAY
a. Remove the clip.
b. Detach the 2 clips and remove the cowl side trim board RH.
c. Remove the relay.




3. INSPECT ACC CUT RELAY




a. Measure the resistance according to the value(s) in the table.

If the result is not as specified, replace the relay.

4. INSTALL ACC CUT RELAY
a. Install the relay.
b. Attach the 2 clips to install the cowl side trim board RH.
c. Install the clip.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.