Power Window Regulator Motor (For Rear Door)
POWER WINDOW REGULATOR MOTOR (for Rear Door)Power Window Regulator Motor (for Rear Door):
REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
2. REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH
3. REMOVE REAR DOOR FRAME GARNISH LH
4. REMOVE COURTESY LIGHT ASSEMBLY
5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
6. REMOVE REAR DOOR NO. 2 TRIM BRACKET
7. REMOVE REAR DOOR SERVICE HOLE COVER LH
8. REMOVE REAR DOOR GLASS RUN LH
9. REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
11. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
a. Using a T25 "TORX" driver, remove the 3 screws and motor.
NOTICE: Be careful when removing the screws as the motor may fall and become damaged.
INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
a. Apply MP grease to the sliding and rotating areas of the regulator motor.
b. Using a T25 "TORX" driver, install the motor with the 3 screws.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
HINT: For a new rear window regulator, the installation position of the regulator will be set when the self-tapping screws are installed.
2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
4. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
5. INSTALL REAR DOOR GLASS RUN LH
6. INSTALL REAR DOOR SERVICE HOLE COVER LH
7. INSTALL REAR DOOR NO. 2 TRIM BRACKET
8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
9. INSTALL COURTESY LIGHT ASSEMBLY
10. INSTALL REAR DOOR FRAME GARNISH LH
11. INSTALL REAR DOOR UPPER ARMREST BASE PANEL LH
12. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH