Radio Antenna

Radio Antenna:

Radio Antenna:

Radio Antenna:

RADIO ANTENNA

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE ANTENNA ORNAMENT




a. Remove the antenna ornament as shown in the illustration.

3. REMOVE FENDER APRON MUDGUARD SEAL RH
4. REMOVE FENDER ANTENNA ASSEMBLY




a. Disconnect the connector.
b. Remove the bolt and detach the 5 clamps.




c. Remove the bolt and antenna.

INSTALLATION

HINT: A bolt without a torque specification is shown in the standard bolt chart.

1. INSTALL FENDER ANTENNA ASSEMBLY




a. Install the antenna with the bolt.




b. Attach the 5 clamps and install the bolt.
c. Connect the connector.

2. INSTALL FENDER APRON MUDGUARD SEAL RH
3. INSTALL ANTENNA ORNAMENT




a. Install the antenna ornament as shown in the illustration.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.