Removal and Replacement

Fog Light Assembly:

FOG LIGHT ASSEMBLY

REMOVAL

HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.

1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH




2. REMOVE FOG LIGHT ASSEMBLY LH
a. for Steel Type Bumper:
1. Disconnect the connector.
2. Push the tabs on the grommet.
3. Detach the 2 claws and remove the fog light.




b. for Resin Type Bumper:
1. Disconnect the connector.
2. Push the tabs on the aiming screw.
3. Detach the 2 claws and remove the fog light.

INSTALLATION

HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.




1. INSTALL FOG LIGHT ASSEMBLY LH
a. for Steel Type Bumper:
1. Attach the 2 claws to install the fog light.
2. Attach the tabs on the fog light aiming screw to the bumper.
3. Connect the connector.




b. for Resin Type Bumper:
1. Attach the 2 claws to install the fog light.
2. Attach the tabs on the fog light aiming screw to the bumper.
3. Connect the connector.

2. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH