Removal and Installation
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY
a. Disconnect the 4 air injection control driver connectors.
b. Remove the bolt.
c. Disconnect the 2 wire harness clamps.
d. Remove the 3 bolts and air injection control driver assembly.
INSTALLATION
1. INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY
a. Install the air injection control driver assembly with the 3 bolts.
Torque: 8.0 N.m (82 kgf. cm, 71 in.lbf)
b. Connect the 2 wire harness clamps.
c. Install the bolt.
Torque: 5.0 N.m (51 kgf. cm, 44 in.lbf)
d. Connect the 4 air injection control driver connectors.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected.