Front Door Lock (For Regular Cab)

Front Door Lock (For Regular Cab):

FRONT DOOR LOCK (FOR REGULAR CAB)

REMOVAL

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
3. REMOVE FRONT ARMREST UPPER BASE PANEL LH
4. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
6. REMOVE COURTESY LIGHT ASSEMBLY
7. REMOVE FRONT DOOR ARMREST COVER LH
8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
9. REMOVE FRONT NO.1 DOOR TRIM BRACKET
10. REMOVE FRONT DOOR SERVICE HOLE COVER LH
11. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
12. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
13. REMOVE FRONT DOOR LOCK ASSEMBLY LH
14. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
15. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
3. INSTALL FRONT DOOR LOCK ASSEMBLY LH
4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
6. INSTALL FRONT DOOR SERVICE HOLE COVER LH
7. INSTALL FRONT NO.1 DOOR TRIM BRACKET
8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
9. INSTALL FRONT DOOR ARMREST COVER LH
10. INSTALL COURTESY LIGHT ASSEMBLY
11. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
12. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
13. INSTALL FRONT ARMREST UPPER BASE PANEL LH
14. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.