Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL1. REMOVE NO. 1 ENGINE UNDER COVER
2. REMOVE V-BANK COVER SUB-ASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR
a. Disconnect the sensor connector.
b. Remove the sensor.
c. Remove the gasket from the sensor.
INSTALLATION
1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
a. Install a new gasket to the sensor.
b. Install the sensor.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
c. Connect the sensor connector.
2. ADD ENGINE COOLANT
3. INSPECT FOR COOLANT LEAK
4. INSTALL V-BANK COVER SUB-ASSEMBLY
5. INSTALL NO. 1 ENGINE UNDER COVER