Rear Door Lock (For Double Cab)

Rear Door Lock (For Double Cab):

REAR DOOR LOCK (FOR DOUBLE CAB)

REMOVAL

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
- Some systems need to be initialized after the cable is reconnected.
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
3. REMOVE REAR DOOR ARMREST UPPER BASE PANEL LH
4. REMOVE REAR DOOR FRAME GARNISH LH
5. REMOVE COURTESY LIGHT ASSEMBLY
6. REMOVE REAR DOOR ARMREST COVER LH
7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
8. REMOVE REAR NO.2 DOOR TRIM BRACKET
9. REMOVE REAR DOOR SERVICE HOLE COVER LH
10. REMOVE REAR DOOR GLASS RUN LH
11. REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
13. REMOVE REAR DOOR LOCK ASSEMBLY LH
14. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
15. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.

1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
3. INSTALL REAR DOOR LOCK ASSEMBLY LH
4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
6. INSTALL REAR DOOR GLASS RUN LH
7. INSTALL REAR DOOR SERVICE HOLE COVER LH
8. INSTALL REAR NO.2 DOOR TRIM BRACKET
9. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
10. INSTALL REAR DOOR ARMREST COVER LH
11. INSTALL COURTESY LIGHT ASSEMBLY
12. INSTALL REAR DOOR FRAME GARNISH LH
13. INSTALL REAR DOOR ARMREST UPPER BASE PANEL LH
14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected.