Drive Belt: Service and Repair

DRIVE BELT

COMPONENTS:

REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE NO. 1 ENGINE UNDER COVER





3. REMOVE FAN AND GENERATOR V BELT
(a) While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of [diameter]5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

HINT: The pulley bolt for the belt tensioner has a left-hand thread.

(b) Remove the V belt.

INSTALLATION





1. INSTALL FAN AND GENERATOR V BELT
(a) Set the V belt onto every part.
(b) While turning the belt tensioner counterclockwise, remove the pin.

NOTICE: Make sure that the V belt is properly set to each pulley.

(c) After installing the belt, check that it fits properly in the ribbed grooves.

HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

2. INSTALL NO. 1 ENGINE UNDER COVER
3. INSTALL V-BANK COVER SUB-ASSEMBLY