Component Tests and General Diagnostics
INSPECTION1. INSPECT TIRE
(a) Check the tires for wear and proper inflation pressure.
Standard cold tire inflation pressure:
(b) Using a dial indicator, check the tire runout.
Tire runout: 3.0 mm (0.118 inch) or less
2. ROTATE TIRE
HINT: Rotate the tires as shown in the illustration.
3. INSPECT WHEEL BALANCE
(a) Check and adjust the off-the-car balance.
(b) If necessary, check and adjust the on-the-car balance.
Standard imbalance after adjustment: 8 g (0.0180 lbs.) or less
NOTICE:
^ Using a cleaning detergent, remove dirt, oil and water from the areas shown in the illustration. Approximately 25 mm (0.993 inch)
^ Do not touch the adhesive part of the balance weight.
^ Adhere the balance weight to the areas shown in the illustration.
^ Push the balance weight securely with your fingers to attach it.
^ Do not reuse the balance weight.
4. INSPECT FRONT AXLE HUB
(a) Inspect the front axle hub.
5. INSPECT REAR AXLE SHAFT
(a) Inspect the rear axle shaft.