Crankshaft, Engine
CrankshaftCrankshaft
Thrust clearance
Standard 0.020 to 0.220 mm (0.000787 to 0.00866 in.)
Maximum 0.30 mm (0.0118 in.)
Thrust washer thickness
Standard 2.44 to 2.49 mm (0.0961 to 0.0980 in.)
Circle runout
Maximum 0.06 mm (0.00236 in.)
Main journal
Diameter
Standard 66.988 to 67.000 mm (2.6373 to 2.6378 in.)
Taper and out-of-round
Maximum 0.02 mm (0.000787 in.)
Crank pin
Diameter
Standard 55.982 to 56.000 mm (2.2040 to 2.2047 in.)
Taper and out-of-round
Maximum 0.02 mm (0.000787 in.)
Oil clearance
No. 1 and No. 5 journal
Standard 0.017 to 0.030 mm (0.000669 to 0.00118 in.)
Maximum 0.050 mm (0.00197 in.)
Other journal
Standard 0.024 to 0.037 mm (0.000945 to 0.00146 in.)
Maximum 0.060 mm (0.00236 in.)
Drive plate and ring gear x Crankshaft
1st 30 N*m (301 kgf*cm, 22 ft.*lbf)
2nd Turn 90°