Back Door Panel Sub-Assembly

BACK DOOR PANEL SUB-ASSEMBLY







HINT:
- Use the same procedures for the RH side and LH side.
- The following procedure is for the LH side.
- Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts (with washers) when making adjustments.







a. Before adjusting the upper end of the back door up and down or left and right, loosen the bolts.
b. Tighten the body side hinge after the adjustment.

Torque: 20 N.m (204 kgf.cm, 15 ft.lbf)







c. Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic hammer.
d. Tighten the striker mounting screws after the adjustment.

Torque: 23 N.m (235 kgf.cm, 17 ft.lbf)