Installation

SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): INSTALLATION

INSTALLATION

1. INSTALL FRONT SEAT ASSEMBLY
(a) Place the front seat assembly in the cabin.
NOTE: Be careful not to damage the vehicle body.

(b) Connect the connectors under the seat.
(c) Temporarily install the front seat assembly with the 4 bolts.
(d) Lift up the seat track adjusting handle and move the seat to the rearmost position.






(e) Tighten the 2 bolts on the front side of the seat.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
HINT: Tighten the bolts in the order indicated in the illustration.

(f) Lift up the seat track adjusting handle and move the seat to the foremost position.






(g) Tighten the 2 bolts on the rear side of the seat.
Torque: 37 Nm (377 kgf-cm, 27 ft-lbf)
HINT: Tighten the bolts in the order indicated in the illustration.

2. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK
(a) During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
If the seat adjusters do not lock simultaneously, loosen the bolts securing the seat to adjust the adjuster position.
3. INSTALL REAR SEAT TRACK COVER






(a) Engage the 4 claws and install the 2 rear seat track covers.
4. INSTALL FRONT INNER SEAT TRACK COVER
(a) Lift up the seat track adjusting handle and move the seat to the rearmost position.






(b) Engage the 2 claws and install the front inner seat track cover.
5. INSTALL FRONT OUTER SEAT TRACK COVER






(a) Engage the 2 claws and install the front outer seat track cover.
6. INSTALL FRONT SEAT HEADREST ASSEMBLY






(a) Install the front seat headrest assembly as shown in the illustration.
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When reconnected the cable, some systems need to be initialized. Repair Instruction - Initialization

8. INSPECT SRS WARNING LIGHT
Diagnosis System