Removal

BRAKE CONTROL: BRAKE CONTROL POWER SUPPLY: REMOVAL

REMOVAL
NOTE: While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

2. REMOVE SERVICE PLUG GRIP

3. REMOVE DECK BOARD ASSEMBLY Removal Part 1, Step 1-62

4. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Removal Part 1, Step 1-62

5. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY Removal Part 1, Step 1-62

6. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Removal Part 1, Step 1-62

7. REMOVE REAR NO. 1 FLOOR BOARD (w/o Rear No. 2 Seat) Removal Part 1, Step 1-62

8. REMOVE REAR SEAT SIDE COVER LH (w/ Rear No. 2 Seat) Removal Part 1, Step 1-62

9. REMOVE DECK SIDE TRIM BOX LH Removal Part 1, Step 1-62

10. REMOVE REAR SEAT SIDE COVER RH (w/ Rear No. 2 Seat) Removal Part 1, Step 1-62

11. REMOVE JACK CARRIER SUPPORT
12. REMOVE JACK CARRIER CUSHION Removal Part 1, Step 1-62

13. REMOVE JACK ASSEMBLY Removal Part 1, Step 1-62

14. REMOVE JACK CARRIER ASSEMBLY Removal Part 1, Step 1-62

15. REMOVE DECK SIDE TRIM BOX RH Removal Part 1, Step 1-62

16. REMOVE DECK FLOOR BOARD ASSEMBLY (w/o Rear No. 2 Seat) Removal Part 1, Step 1-62

17. REMOVE REAR MAT Removal Part 1, Step 1-62

18. REMOVE DECK FLOOR BOARD ASSEMBLY (w/ Rear No. 2 Seat) Removal Part 1, Step 1-62

19. REMOVE REAR DECK FLOOR BOX (w/o Rear No. 2 Seat) Removal Part 1, Step 1-62

20. REMOVE BRAKE CONTROL POWER SUPPLY WITH BRACKET
CAUTION: Immediately after removing the brake control power supply from the vehicle, there may be an electrical charge left in the internal capacitor. If planning to inspect the inside of the brake control power supply, leave it as is for more than 24 hours (to discharge it) after removing it from the vehicle. Then, perform the inspection.





(a) Disconnect the connector.






(b) Remove the bolt, 2 nuts and the brake control power supply with bracket.
21. REMOVE BRAKE CONTROL POWER SUPPLY






(a) Remove the 2 bolts and No. 1 brake control power supply bracket.
NOTE: Do not drop the brake control power supply. If the brake control power supply has been dropped, replace the brake control power supply with a new one.





(b) Remove the 2 bolts and No. 2 brake control power supply bracket.
NOTE: Do not drop the brake control power supply. If the brake control power supply has been dropped, replace the brake control power supply with a new one.