Cylinder Head Assembly: Specifications

CYLINDER HEAD SUB-ASSEMBLY


CYLINDER HEAD LH

Bank 2:

New cylinder head gasket L mark upward
Torque: 54 Nm (551 kgf-cm, 40 ft-lbf)

CYLINDER HEAD RH

Bank 1:

New cylinder head gasket R mark upward
Torque: 54 Nm (550 kgf-cm, 40 ft-lbf)

NOTE: The cylinder head bolts are tightened in 2 successive steps.





Mark the front side of each cylinder head bolt head with paint as shown in the illustration.
Retighten the cylinder head bolts by 90° in the same sequence as step (c).
Check that each painted mark is now at a 90° angle to the front.

CYLINDER HEAD SET BOLT

Standard outside diameter:
8.95 to 9.05 mm (0.3524 to 0.3563 in.)
Minimum outside diameter:
8.75 mm (0.3445 in.)

CYLINDER HEAD SUB-ASSEMBLY

Maximum Warpage:





INTAKE MANIFOLD





Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)

CAMSHAFT





Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)

NO. 2 CAMSHAFT





Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)

NO. 3 CAMSHAFT SUB-ASSEMBLY





Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)

NO. 4 CAMSHAFT SUB-ASSEMBLY





Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)

CAMSHAFT TIMING GEAR ASSEMBLY

Torque: 150 Nm (1530 kgf-cm, 111 ft-lbf)

EXHAUST MANIFOLD SUB-ASSEMBLY RH





Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)

NO. 2 EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY





Nut - Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
Bolt - Torque: 58 Nm (591 kgf-cm, 43 ft-lbf)