On-Vehicle inspection

METER: METER / GAUGE SYSTEM: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT SPEEDOMETER
(a) Check the operation.
(1) Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.

Reference: mph (for U.S.A.)





Reference: km/h (for Canada)





NOTE: Tire wear as well as over or under inflation will cause errors.
(2) Check the deviation from the acceptable range of the speedometer indication.
Reference:
Less than 0.5 km/h (0.3 mph)
HINT: If the indication is not as specified, go to problem symptoms table Problem Symptoms Table.

2. INSPECT MULTI-INFORMATION DISPLAY






(a) Power switch off.
(b) Press the "DISP" button and hold it down.
(c) Power switch on (READY).
OK:
All the dots in the multi-information display come on.
HINT: This test is also available on "Active Test" Scan Tool Testing and Procedures.

(d) Power switch off to finish this test mode.
HINT: If the result is not as specified, replace the clock assembly Removal.