Light Control Switch Circuit

LIGHTING: LIGHTING SYSTEM: Light Control Switch Circuit

Light Control Switch Circuit

DESCRIPTION

The main body ECU receives the following signals:

- Light control switch TAIL, HEAD, or AUTO signal
- Dimmer switch HIGH or HIGH FLASH (PASS) signal
- Front fog light switch signal
HINT: When performing troubleshooting, inspect the switch that is related to the malfunction. For example, if both right and left low beam headlights do not illuminate, read the light control switch HEAD signal value only in the data list. If the value is normal, perform the headlight relay active test.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Data List.
(e) Read the display on the Techstream.

Main Body





OK:
Normal conditions listed above are displayed.
NG -- INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Inspect the headlight dimmer switch assembly Testing and Inspection.
OK:
Headlight dimmer switch assembly is normal.
NG -- REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK - SWITCH ASSEMBLY)





(a) Disconnect the D13 headlight dimmer switch assembly connector.
(b) Disconnect the D7 and D8 main body ECU connectors.
(c) Disconnect the 1N instrument panel junction block connector.
(d) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)