Removal

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Repair Instruction - Initialization

2. REMOVE SERVICE PLUG GRIP

3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal

4. REMOVE FRONT DOOR SCUFF PLATE LH Removal Part 1, Step 1-62

5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal Part 1, Step 1-62

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

7. REMOVE FRONT DOOR SCUFF PLATE RH Removal Part 1, Step 1-62

8. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal Part 1, Step 1-62

9. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

10. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

12. REMOVE NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System) Removal

13. REMOVE LOWER REAR CONSOLE BOX Removal

14. REMOVE CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System) Removal

15. REMOVE CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System) Removal

16. REMOVE FRONT NO. 1 CONSOLE BOX INSERT Removal

17. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal

18. REMOVE YAW RATE AND ACCELERATION SENSOR






(a) Disconnect the connector from the yaw rate and acceleration sensor.






(b) Remove the 2 bolts and yaw rate and acceleration sensor.
NOTE: Do not remove the nuts.