Reading and Clearing Diagnostic Trouble Codes

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: DTC CHECK / CLEAR

DTC CHECK / CLEAR

1. DTC CHECK (USING SST CHECK WIRE)
(a) Turn the power switch off.





(b) Using SST, connect terminals TC and CG of the DLC3.
SST: 09843-18040
(c) Turn the power switch on (IG).
(d) Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration as examples of the normal system code and codes 13 and 33.
HINT:
- If the tire pressure warning light does not indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC and CG terminal circuit.





- If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.

(e) Refer to the Diagnostic Trouble Code Chart for DTC information.
(f) After completing the check, turn the power switch off and remove SST from the DLC3.
SST: 09843-18040
2. DTC CHECK (USING TECHSTREAM)
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and turn the Techstream on.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(e) Read the DTCs following the prompts on the Techstream screen.
HINT: Refer to the Techstream operator's manual for further details.

3. CLEAR DTC
HINT: After repairing the malfunctions, clear the DTCs.

(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and turn the Techstream on.
(d) Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
(e) Clear the DTCs following the prompts on the Techstream screen.
HINT: Refer to the Techstream operator's manual for further details.