Continuously Variable Transmission/Transaxle: Testing and Inspection

P310 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE SYSTEM: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT OIL PRESSURE IN OIL PUMP

NOTE: Perform this inspection at normal operating oil temperature 50 to 80°C (122 to 176°F).

(a) Lift up the vehicle.






(b) Remove the fluid pump cover plug and install SST.
SST: 09992-00095
09992-00112
09992-00271
(c) Enter 2WD inspection mode. Component Tests and General Diagnostics
(d) Measure the oil pressure.
Oil pressure:





NOTE: Be sure to cancel the inspection mode immediately after the oil pressure check is completed. Component Tests and General Diagnostics





(e) Install a new O-ring and fluid pump cover plug.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)

For furthur testing information please refer to:
Hybrid Drive Systems Testing and Inspection. Testing and Inspection
Power Control System, Hybrid Drive. Power Control System