Operation CHARM: Car repair manuals for everyone.

Vehicle Stability Control System








BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C0226/21: SFR Solenoid Circuit

DTC C0226/21 - SFR Solenoid Circuit

DTC C0236/22 - SFL Solenoid Circuit

DTC C0246/23 - SRR Solenoid Circuit

DTC C0256/24 - SRL Solenoid Circuit

DESCRIPTION

This solenoid goes on when signals are received from the ECU and controls the pressure acting on the wheel cylinders to control the braking force.






WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. RECONFIRM DTC
HINT: This code is detected when a problem is determined in the brake actuator assembly.
The solenoid circuit is in the brake actuator assembly.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the brake actuator assembly.
(a) Clear the DTCs .
(b) Turn the ignition switch to the ON position.
(c) Are the same DTCs recorded?
Result:





NOTE: When replacing the brake actuator assembly, perform zero point calibration .

B -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
A -- REPLACE BRAKE ACTUATOR ASSEMBLY