Pinout Values and Diagnostic Parameters

MIRROR: POWER MIRROR CONTROL SYSTEM (w/ Memory): TERMINALS OF ECU

TERMINALS OF ECU

1. CHECK OUTER MIRROR CONTROL ECU LH





(a) Disconnect the O9 and O10 connectors.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Voltage:






Resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the O9 and O10 connectors.
(d) Measure the voltage according to the value(s) in the table below.
Voltage:





If the result is not as specified, there may be a malfunction on the ECU side.
2. CHECK OUTER MIRROR CONTROL ECU RH





(a) Disconnect the O11 and O12 connectors.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Voltage:






Resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the O11 and O12 connectors.
(d) Measure the voltage according to the value(s) in the table below.
Voltage:





If the result is not as specified, there may be a malfunction on the ECU side.