Canada - Body - Power Sliding Door Initialization Procedure

Bulletin
2873

Issue Date
September 13, 2007

Market
Canada

Title:
INITIALIZATION OF POWER SLIDING DOORS DURING PDS

Component
GENERAL INFORMATION

Models
'08 - '09 Sienna

INTRODUCTION:
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the power sliding doors will be inoperative due to loss of the Power Sliding Doors position memory stored in the microcomputer.

Initialize the Power Sliding Doors after installing the Short Pin in its original location during Pre-Delivery Service at the dealership.

NOTE:
Any time the battery terminal has been disconnected, re-initialize the Power Sliding Doors after reconnecting the battery terminal.







APPLICABLE VEHICLES:
- 2008 - 2009 model year Sienna vehicles.







WARRANTY INFORMATION:


INITIALIZATION PROCEDURE:







1. Fully close the power sliding doors.
2. Check that the power sliding doors fully open and fully close.

A. Check that the power sliding doors are unlocked. If NOT, press the transmitter switch or the door control switch.
B. Turn the ignition switch to the "OFF" position.
C. Check that the power sliding door main switch is in the "ON" position.
D. Check that the power sliding doors fully open and fully close by pushing the power slide door satellite switch or transmitter switch or power slide control switch.

NOTE:
Jam protection function becomes effective through the above initialization procedure.