Component Tests and General Diagnostics

TIRE AND WHEEL: TIRE AND WHEEL SYSTEM: INSPECTION

INSPECTION

1. INSPECT TIRES
(a) Check the tires for wear and proper inflation pressure.
Cold tire inflation pressure:










(b) Using a dial indicator, check the runout of the tires.
Tire runout:
1.4 mm (0.055 in.) or less






2. ROTATE TIRES
HINT: Rotate the tires as shown in the illustration.

3. INSPECT WHEEL BALANCE (for Steel Wheel)






(a) Check and adjust the off-the-car balance.
Imbalance after adjustment:
8.0 g (0.018 lb.) or less.
HINT: If necessary, check and adjust the on-the-car balance.

4. INSPECT WHEEL BALANCE (for Non-steel Wheel)






(a) Check and adjust the off-the-car balance.
Imbalance after adjustment:
8.0 g (0.018 lb.) or less.
- Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
- Do not touch the sticking surface of the tape.
- Adhere the sticking type balance weight to the flat position shown in the illustration.
- Push the balance weight securely with a finger to adhere it to the position.
- Do not reuse the balance weight.
- The inner side balance weight should be installed by clipping it to the rim.
- If necessary, check and adjust the on-the-car balance.

5. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub.

6. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 2WD) Rear Axle Hub and Bearing.

7. INSPECT REAR AXLE HUB BEARING LOOSENESS (for 4WD) Rear Axle Hub and Bearing.

8. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub.

9. INSPECT REAR AXLE HUB RUNOUT (for 2WD) Rear Axle Hub and Bearing.

10. INSPECT REAR AXLE HUB RUNOUT (for 4WD) Rear Axle Hub and Bearing.