Installation

STEERING COLUMN: STEERING COLUMN ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL STEERING COLUMN ASSEMBLY






(a) Install the steering column assembly with the 3 bolts.
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
(b) Connect the connectors.
(c) Connect the wire harness clamps to the steering column tube.
2. CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY






(a) Align the matchmarks on the intermediate shaft assembly and steering gear assembly.
(b) Install the steering intermediate shaft assembly with the bolt.
Torque: 36 Nm (370 kgf-cm, 27 ft-lbf)






(c) Install the dust cover to the hole cover. Check that the 3 clips of the dust cover are securely fitted into the groove on the hole cover.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. INSTALL SPIRAL CABLE SUB-ASSEMBLY Installation

5. INSTALL STEERING COLUMN COVER
6. CENTER SPIRAL CABLE Installation

7. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft assembly.
(b) Install the steering wheel assembly set nut.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
(c) Connect the connector.
8. INSPECT STEERING WHEEL CENTER POINT
9. INSPECT HORN BUTTON ASSEMBLY Installation

10. INSTALL HORN BUTTON ASSEMBLY Installation

11. INSTALL STEERING WHEEL COVER LOWER NO.3 Installation

12. INSTALL STEERING WHEEL COVER LOWER NO.2 Installation

13. CONNECT BATTERY NEGATIVE TERMINAL
14. INSPECT SRS WARNING LIGHT Installation