Body - Driver's Power Window Initialization Procedure

PRE-DELIVERY SERVICE
PD077-07

Title:
INITIALIZATION OF DRIVER'S DOOR
POWER WINDOW DURING PDS

Models:
'08 Sienna

June 29, 2007

Introduction

As a result of the removal of the Short Pin, the "one-touch open and close" and "jam protection" functions of the driver's door power window will be inoperative due to loss of the driver's door window position memory stored in the microcomputer.

Initialize the driver's door power window after installing the Short Pin in its original location during Pre-Delivery Service (PDS) at the dealership.

Any time the battery terminal has been disconnected, the driver's door power window MUST be re-initialized.

Applicable Vehicles

^ 2008 model year Sienna vehicles.





Warranty Information

Initialization Procedure





1. Turn the ignition switch to the "IG-ON" position.

NOTE:
At this time, the power window switch for the driver's door window should be blinking.





2. Push the driver's door power window switch to open the window.

3. Pull up the driver's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.

4. Check for proper operation of the "one-touch open and close" by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.

NOTE:
Jam protection function becomes effective through the above initialization procedure.