Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY






(a) Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.
- Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
- Connect the connectors if necessary.





(b) Install the 5 clips.






(c) Connect the engine under cover to the front bumper assembly with the 8 screws.
Torque: 7.0 Nm (71 kgf-cm, 62.0 in-lbf)






(d) Connect the fender liner to the front bumper assembly with the 4 screws.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

4. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

5. FOG LIGHT AIMING INSPECTION (w/ Fog Light) Adjustments

6. FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) Adjustments