Installation

BRAKE: REAR DISC BRAKE: INSTALLATION

INSTALLATION
HINT: Install the RH side by the same procedure as the LH side.

1. INSTALL REAR DISC BRAKE CYLINDER MOUNTING LH
(a) Install the rear disc brake cylinder mounting LH with the 2 bolts.
Torque: 88 Nm (900 kgf-cm, 65 ft-lbf)
2. INSTALL REAR DISC BRAKE PAD SUPPORT PLATE
(a) Install the rear disc brake pad support plate (No. 1) and rear disc brake pad support plate (No. 2) to the rear disc brake cylinder mounting LH.
3. INSTALL REAR DISC BRAKE ANTI SQUEAL SHIM KIT
NOTE: If necessary, replace the anti squeal shim kit when replacing the brake pad.

(a) Apply disc brake grease to each anti squeal shim No. 1.
(b) Install anti squeal shims No. 1 and anti squeal shim No. 2 on each pad.
4. INSTALL DISC BRAKE PAD KIT REAR (PAD ONLY)
(a) Install the brake pad kit rear to the rear disc brake cylinder mounting LH.
NOTE: There should be no oil or grease on the friction surfaces of the pads and the disc.

5. INSTALL DISC BRAKE CYLINDER ASSEMBLY REAR LH
(a) Install the disc brake cylinder assembly rear LH with the 2 bolts.
Torque: 34 Nm (350 kgf-cm, 25 ft-lbf)
6. CONNECT REAR LH FLEXIBLE HOSE






(a) Using SST, Install the rear brake flexible hose.
SST: 09023-12701
Torque: 23 Nm (235 kgf-cm, 17 ft-lbf)
7. CONNECT REAR BRAKE TUBE NO.4
(a) Install the clip and connect the rear brake flexible hose.






(b) Using SST and a spanner, connect the rear brake tube No. 4.
SST: 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
8. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

9. BLEED BRAKE MASTER CYLINDER Service and Repair

10. BLEED BRAKE LINE Service and Repair

11. BLEED BRAKE ACTUATOR (w/ VSC) Service and Repair

12. CHECK FLUID LEVEL IN RESERVOIR Service and Repair

13. INSPECT FOR BRAKE FLUID LEAK
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)