Reassembly

BRAKE: REAR DRUM BRAKE: REASSEMBLY

REASSEMBLY

1. INSTALL REAR WHEEL CYLINDER CUP KIT
(a) Temporarily tighten the bleeder plug to the wheel cylinder, and install the bleeder plug cap.

(b) Apply lithium soap base glycol grease to the 2 new wheel cylinder cups and the 2 pistons.
(c) Install the 2 wheel cylinder cups to each piston.
(d) Install the compression spring and 2 pistons to the rear wheel brake cylinder.
(e) Install the 2 new cylinder dust boots to the rear wheel brake cylinder.
2. INSTALL LH, FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY

(a) Install the rear wheel brake cylinder assembly with the 2 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Using SST, connect the brake tube.
SST: 09023-00101
Torque: 15 Nm (155 kgf-cm, 11 ft-lbf)
3. APPLY HIGH TEMPERATURE GREASE

(a) Apply high temperature grease to the shoe attached surface of backing plate.
4. INSTALL REAR BRAKE SHOE
(a) Apply high temperature grease to the adjusting bolt.
(b) Install the rear brake strut set with the shoe return spring.

(c) Using a pliers, install the rear brake strut set, parking brake reaction lever and parking brake shoe lever LH with the 2 new C-washers.

(d) Using a needle-nose pliers, connect the parking brake cable No. 3 to the parking brake shoe lever LH.

(e) Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
SST: 09718-00010
5. INSTALL FRONT BRAKE SHOE
(a) Install the rear brake automatic adjust lever LH, automatic adjust lever spring and parking brake shoe strut LWR to the front brake shoe.

(b) Using SST, install the front brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
SST: 09718-00010

(d) Using a needle-nose pliers, install the return spring.

(e) Using SST, install the shoe return spring to the front brake shoe.
SST: 09921-00010
6. CHECK REAR DRUM BRAKE INSTALLATION
(a) Check that each part is installed properly.

(b) Measure the brake drum inside diameter and the diameter of the brake shoes. Check that difference between the diameter is the correct shoe clearance.
Shoe clearance:
0.5 mm (0.020 in.)
NOTE: There should be no oil or grease adhering to the friction surfaces of the shoe lining and the drum.

7. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
8. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
(a) Temporarily install the hub nuts.
(b) Remove the hole plug, and turn the adjuster and expand the shoe until the drum locks.

(c) Using a screwdriver, back off the adjuster 15 notches.
(d) Install the hole plug.
9. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

10. BLEED BRAKE MASTER CYLINDER Service and Repair

11. BLEED BRAKE LINE Service and Repair

12. BLEED BRAKE ACTUATOR (w/ VSC) Service and Repair

13. CHECK FLUID LEVEL IN RESERVOIR Service and Repair

14. INSPECT FOR BRAKE FLUID LEAK
15. INSTALL REAR WHEEL
Torque: 103 Nm (,050 kgf-cm, 76 ft-lbf)
16. INSPECT PARKING BRAKE PEDAL TRAVEL
17. ADJUST PARKING BRAKE PEDAL TRAVEL