Reassembly

AXLE: FRONT AXLE HUB: REASSEMBLY

REASSEMBLY

1. INSTALL FRONT AXLE HUB LH BEARING






(a) Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.
SST: 09950-60020
09951-00810
SST: 09950-70010
09951-07100
2. INSTALL DISC BRAKE DUST COVER FRONT LH
(a) Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.
Torque: 8.3 Nm (85 kgf-cm, 74 in-lbf)
HINT: Torx is a registered trademark of Textron Inc.

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH






(a) Using SST(s), and a press, install the front axle hub sub-assembly LH.
SST: 09608-32010
SST: 09950-60020
09951-00810
SST: 09950-70010
09951-07100
4. INSTALL FRONT AXLE HUB LH HOLE SNAP RING






(a) Using snap ring pliers, install a new front axle hub LH hole snap ring.
5. INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH






(a) Using SST(s) and a hammer, install the bearing dust deflector No. 1 LH.
SST: 09316-60011
09316-00011
09316-00031
SST: 09608-32010
HINT: Align the hole for the speed sensor in the bearing dust deflector No. 1 LH with the steering knuckle.

6. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH
(a) Install the lower ball joint assembly front LH and tighten the nut.
Torque: 123 Nm (1,250 kgf-cm, 91 ft-lbf)
(b) Install a new cotter pin.
NOTE: If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.