Canada - Moonroof - Initialization Procedure

Bulletin
2872

Issue Date
September 13, 2007

Market
Canada

Title:
INITIALIZATION OF MOON ROOF DURING PDS

Component
GENERAL INFORMATION

Models
'08 - '09 Sienna

INTRODUCTION:
As a result of the removal of the Short Pin, the "one-touch tilt up and down," "one-touch slide open and close," and "jam protection" functions of the moon roof will be inoperative due to loss of the moon roof position memory stored in the microcomputer.

Initialize the moon roof after installing the Short Pin in its original location during Pre-Delivery Service (PDS) at the dealership.

NOTE:
Any time the battery terminal has been disconnected, re-initialize the Moon Roof after reconnecting the battery terminal.

APPLICABLE VEHICLES:
- 2008 - 2009 model year Sienna vehicles.







WARRANTY INFORMATION:







INITIALIZATION PROCEDURE:
1. Turn the ignition switch to the "IG-ON" position.
2. Push and hold the "TILT UP" side of the switch until the Moon Roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.4 in.] at rear end).
3. Check for proper operation of the "One-touch slide open/close" and "One-touch tilt up/down" functions by pushing the switch briefly to the "SLIDE OPEN" and "TILT UP positions."

NOTE:
Jam protection function becomes effective through the above initialization procedure.