Reassembly

U151E AUTOMATIC TRANSAXLE: FORWARD CLUTCH: REASSEMBLY

REASSEMBLY

1. INSTALL INPUT SHAFT OIL SEAL RING






(a) Compress a new input shaft oil seal ring from both sides to reduce dimension A.
Dimension A:
5 mm (0.197 in.)
(b) Coat the oil seal ring with ATF and install it to the input shaft.
NOTE: Do not expand the end gap of the oil seal ring too much. Fix the hooks firmly.

2. INSTALL FORWARD CLUTCH PISTON SUB-ASSEMBLY






(a) Coat the forward clutch piston with ATF, and install it to the input shaft.
NOTE: Be careful not to damage the lip of the forward clutch piston.

3. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY






(a) Install the return spring to the input shaft.
NOTE: Installing the spring sub-assembly, check that all of the springs are fit in the piston correctly.

(b) Coat the clutch balancer with ATF.






(c) Install the clutch balancer to the input shaft.
- Be careful not to damage the lip of the forward clutch balancer.
- Make sure that the clutch balancer is not pinched and that there are no other defects at the lip.
- Apply sufficient ATF to the sealing lip before installation.





(d) Place SST on the clutch balancer, and compress the clutch balancer with a press.
SST: 09387-00020
(e) Install the snap ring with a snap ring expander.
(f) Be sure that the end gap of the snap ring is not aligned with the spring retainer claw.
NOTICE:
- Stop the press when the spring seat is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove.
- This prevents the spring seat from being deformed.
- Do not expand the snap ring excessively.





(g) Set the end gap of the snap ring in the piston as shown in the illustration.
NOTE: The end gap of the snap ring should not align with any of the stoppers.

4. INSTALL FORWARD MULTIPLE DISC CLUTCH DISC
(a) Coat the 5 discs with ATF.






(b) Install the 5 plates, 5 discs and flange input shaft.
NOTE: Make sure that the plates, discs, and flange are installed as shown in the illustration.





(c) Using a screwdriver, install the snap ring.
(d) Check that the end gap of the snap ring is not aligned with one of the cutouts.
NOTE: The snap ring should be fully engaged in the groove of the drum.

5. INSPECT PACK CLEARANCE OF FORWARD CLUTCH Forward Clutch

6. INSPECT FORWARD MULTIPLE DISC CLUTCH DISC Forward Clutch