Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT CUSHION ASSEMBLY (w/ Occupant Classification ECU, Occupant Classification Sensor):

INSTALLATION

NOTICE:
- Install new parts from prepared service kits.
- Never use SRS parts from another vehicle. When replacing the parts, replace them with new ones.
- Never reuse an occupant classification sensor involved in a collision when the airbag has deployed.
- If the occupant classification sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the occupant classification sensor, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
- After installing, shake the occupant classification sensor to check that there is no looseness.
- Remove the front seat cushion cover pad and front seat cushion cover together, in order to avoid occupant classification sensor malfunctions.

1. INSTALL OCCUPANT CLASSIFICATION SENSOR
(a) Install the occupant classification sensor with the 2 clips.
(b) Engage the clamps to the seat cushion frame.
(c) Pass the tube of the occupant classification sensor through marked portion A and then fix it at marked portion B on the front seat cushion spring assembly with the wiring harness clamp, as shown in the illustration on the following page.

HINT: Cut the wiring harness clamp leaving 5 to 10 mm (0.20 to 0.39 in.) at the end.

(d) Connect the connector to the occupant classification sensor.





2. INSTALL FRONT SEAT CUSHION SPRING ASSEMBLY (Reassembly)

3. INSTALL FRONT SEAT OUTER TRACK ASSEMBLY LH (Reassembly)

4. INSTALL FRONT SEAT OUTER TRACK ASSEMBLY RH (Reassembly)

5. INSTALL FRONT SEAT TRACK LOWER REAR BRACKET LH (Reassembly)

6. INSTALL FRONT SEAT TRACK LOWER REAR BRACKET RH (Reassembly)

7. INSTALL FRONT SEAT TRACK LOWER FRONT BRACKET LH (Reassembly)

8. INSTALL FRONT SEAT TRACK LOWER FRONT BRACKET RH (Reassembly)

9. INSTALL OCCUPANT CLASSIFICATION ECU (Installation)

10. INSTALL FRONT SEATBACK ASSEMBLY (Reassembly)

11. INSTALL FRONT SEAT HINGE COVER LH (Reassembly)

12. INSTALL FRONT SEAT HINGE COVER RH (Reassembly)

13. INSTALL FRONT SEAT ASSEMBLY (Installation)

14. INSTALL FRONT SEAT HEADREST ASSEMBLY (Installation)

15. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (Installation)

16. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (Installation)

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
18. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK (Initialization)

19. INSPECT SRS WARNING LIGHT (Diagnosis System)