Entire Combination Meter Does Not Operate

METER: METER / GAUGE SYSTEM: Entire Combination Meter does not Operate

Entire Combination Meter does not Operate

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK FUSE





(a) Remove the ECU-B fuse, AM2 fuse and short pin from the engine room R/B.
(b) Remove the GAUGE fuse from the driver side J/B.
(c) Measure the resistance.
Standard Resistance:
Below 1 Ohms
(d) Reinstall the fuses and short pin.
NG -- INSPECT FOR SHORT CIRCUIT IN HARNESS AND ALL COMPONENTS CONNECTED TO FUSE
OK -- Continue to next step.
2. INSPECT COMBINATION METER ASSEMBLY





(a) Disconnect the C9 combination meter connector.
(b) Measure the resistance.
Standard Resistance:





(c) Measure the voltage.
Standard Voltage:





(d) Reconnect the combination meter connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY