Crankshaft, Engine
CRANKSHAFTThrust clearance
STD 0.020 to 0.220 mm (0.0008 to 0.0087 in.)
Maximum 0.30 mm (0.0118 in.)
Thrust washer thickness 2.440 to 2.490 mm (0.0961 to 0.0980 in.)
Crankshaft journal bore diameter on cylinder block with bearing (Reference)
Mark 1 64.004 to 64.010 mm (2.5198 to 2.5201 in.)
Mark 2 64.011 to 64.016 mm (2.5201 to 2.5203 in.)
Mark 3 64.017 to 64.022 mm (2.5203 to 2.5206 in.)
Crankshaft journal oil clearance
STD No. 3 0.030 to 0.055 mm (0.0012 to 0.0022 in.)
STD Others 0.024 to 0.049 mm (0.0009 to 0.0019 in.)
Maximum 0.10 mm (0.0039 in.)
Crankshaft journal diameter
No. 3 59.981 to 59.994 mm (2.3615 to 2.3620 in.)
Others 59.987 to 60.000 mm (2.3619 to 2.3622 in.)
Crankshaft bearing center wall thickness (Reference)
Mark 1 1.987 to 1.990 mm (0.0782 to 0.0783 in.)
Mark 2 1.990 to 1.993 mm (0.0784 to 0.0785 in.)
Mark 3 1.943 to 1.996 mm (0.0785 to 0.0786 in.)
Crank pin diameter 52.989 to 53.002 mm (2.0862 to 2.0867 in.)
Circle runout
Maximum 0.03 mm (0.0012 in.)
Crankshaft journal taper and out-of-round
Maximum 0.005 mm (0.0002 in.)
Crank pin taper and out-of-round
Maximum 0.003 mm (0.0001 in.)