Removal

ENGINE IMMOBILISER: TRANSPONDER KEY ECU:

REMOVAL

1. REMOVE INSTRUMENT PANEL SAFETY PAD
(a) Remove the instrument panel safety pad (Removal).
2. REMOVE NO. 1 HEATER TO REGISTER DUCT (Removal)

3. REMOVE NO. 3 HEATER TO REGISTER DUCT (w/ Bracket) (Removal)

4. REMOVE NO. 2 REAR AIR DUCT (for Double Cab w/ Bracket) (Removal)

5. REMOVE NO. 1 REAR AIR DUCT (for Double Cab w/ Bracket) (Removal)

6. REMOVE AIR DUCT ASSEMBLY LH (w/ Bracket) (Removal)

7. REMOVE AIR DUCT ASSEMBLY RH (w/ Bracket) (Removal)

8. REMOVE NO. 1 INSTRUMENT PANEL BRACE MOUNTING BRACKET (w/ Bracket) (Removal)

9. REMOVE STEERING COLUMN HOLE COVER (w/ Bracket) (Removal)

10. SEPARATE STEERING SLIDING YOKE (w/ Bracket) (Removal)

11. REMOVE STEERING COLUMN ASSEMBLY (w/ Bracket) (Removal)

12. REMOVE PARKING BRAKE CONTROL LEVER ASSEMBLY (for Manual Transmission w/ Bracket) (Removal)

13. REMOVE ECM (for 2TR-FE w/ Bracket)

14. REMOVE ECM (for 1GR-FE w/ Bracket)

15. REMOVE DRIVER SIDE JUNCTION BLOCK (w/ Bracket) (Removal)

16. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ Bracket) (Removal)

17. REMOVE REINFORCEMENT ASSEMBLY (w/ Bracket)

(a) Disconnect the transponder key ECU connector.
(b) Disengage the 4 clamps and disconnect the 6 connectors from the air conditioning unit assembly.

(f) Disengage the 20 clamps.

(g) Remove the 5 bolts.
(h) Remove the 2 caps and 7 bolts.
(i) Disengage the reinforcement hook from the air conditioning unit, and remove the reinforcement.

18. REMOVE TRANSPONDER KEY BRACKET (w/ Bracket)
(a) Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 3 screws.

(b) Using a screw extractor, remove the 3 screws and the transponder key bracket from the reinforcement.
19. REMOVE TRANSPONDER KEY ECU (w/ Bracket)

(a) Remove the nut and transponder key ECU.
20. REMOVE TRANSPONDER KEY ECU (w/o Bracket)

(a) Disconnect the connector.
(b) Remove the nut and transponder key ECU.