Clutch Pedal Position Sensor / Switch: Testing and Inspection

CLUTCH START CANCEL SWITCH:

INSPECTION

1. INSPECT CLUTCH START CANCEL SWITCH ASSEMBLY





(a) Using an ohmmeter, check that there is resistance between terminals 2 and 4.
Standard:
10 k Ohms or higher
If the result is not as specified, replace the clutch start cancel switch.





(b) Connect the positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.
(c) Using an ohmmeter, check that there is resistance between terminals 2 and 4.
Standard:
10 k Ohms or higher
If the result is not as specified, replace the clutch start cancel switch.





(d) Check that the indicator light comes on and there is resistance between terminals 2 and 4 when the switch is pressed.
Standard:
Below 1 Ohms
If the result is not as specified, replace the clutch start cancel switch.





(e) Using an ohmmeter, check that there is resistance between terminals 2 and 4 when the battery lead is disconnected.
Standard:
10 k Ohms or higher
If the result is not as specified, replace the clutch start cancel switch.