Removal

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR:

REMOVAL

HINT: Use the same procedures for RH side and LH side.

1. PRECAUTION (Service Precautions)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
3. REMOVE REAR SEAT BACK HINGE COVER (Removal)

4. REMOVE REAR SEAT BACK ASSEMBLY LH (Removal)

5. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY LH (Removal)

6. REMOVE REAR DOOR SCUFF PLATE LH (Removal)

7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH (Removal)

8. REMOVE LUGGAGE COMPARTMENT SIDE TRAY (Removal)

9. REMOVE QUARTER TRIM LOWER PANEL LH (Removal)

10. REMOVE QUARTER INSIDE TRIM BOARD LH (Removal)

11. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH (Removal)





12. REMOVE REAR AIRBAG SENSOR
(a) Disconnect the connector from the rear airbag sensor.
(b) Remove the nut and the rear airbag sensor.