Installation

BRAKE CONTROL: STEERING ANGLE SENSOR (w/ VSC):

INSTALLATION





1. INSTALL STEERING SENSOR
(a) Install the steering sensor onto the spiral cable.

NOTICE:
- Engage the claws securely.
- Be careful not to damage the claws.

2. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. INSTALL SPIRAL CABLE (Installation)

4. CENTER SPIRAL CABLE (Installation)

5. INSTALL STEERING COLUMN COVER UPPER (Installation)

6. INSTALL STEERING COLUMN COVER LOWER (Installation)

7. INSTALL STEERING WHEEL ASSEMBLY (Installation)

8. INSTALL STEERING PAD ASSEMBLY (Installation)

9. INSTALL STEERING WHEEL COVER LOWER NO. 3 (Installation)

10. INSTALL STEERING WHEEL COVER LOWER NO. 2 (Installation)

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)

12. INSPECT STEERING PAD ASSEMBLY
13. INSPECT SRS WARNING LIGHT (Diagnosis System)