Installation

A750F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH:

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY





(a) Install the park/neutral position switch onto the manual valve lever shaft and provisionally tighten the adjusting bolt.





(b) Install the grommet, a new lock washer and the nut.
Torque: 6.9 Nm (70 kgf-cm, 61 in-lbf)
(c) Install the manual valve lever shaft onto the groove and turn it 2 notches counterclockwise to the neutral position.
(d) Align the neutral basic line with the switch groove and tighten the adjusting bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
(e) Bend the tabs of the lock washer.

HINT: Bend at least 2 of the lock washer tabs.

2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 in-lbf)
4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Adjustments)

5. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Adjustments)

6. ADJUST SHIFT LEVER POSITION

7. INSPECT SHIFT LEVER POSITION