Pressure Plate

CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.

Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.

Torque 19 Nm (195 kgf-cm, 14 ft-lbf)

HINT:
- Following the order in the illustration, uniformly tighten the bolts.
- Move SST up and down, right and left lightly, after checking that the disc is in the center, and tighten the bolts.