Replacement

2UZ-FE ENGINE MECHANICAL: CYLINDER BLOCK: REPLACEMENT

REPLACEMENT

1. REPLACE RING PIN

NOTE: It is not necessary to remove the ring pin unless it is being replaced.

(a) Remove the ring pin.
(b) Using a plastic-faced hammer, tap in new ring pins until they stop.





2. REPLACE STRAIGHT PIN

NOTE: It is not necessary to remove the straight pin unless it is being replaced.

(a) Remove the straight pin.
(b) Using a plastic-faced hammer, tap in new straight pins until they stop.





3. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTE: If water leaks from the tight plug or the plug corrodes, replace it.

(a) Remove the tight plugs.





(b) Apply adhesive to the holes' inner circumference where the tight plugs contact.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(c) Using SST and a hammer, tap in new tight plugs as shown in the illustration.
SST: 09950-60010
09951-00340
SST: 09950-70010
09951-07100