Component Tests and General Diagnostics

TIRE AND WHEEL SYSTEM:

INSPECTION

1. INSPECT TIRE
(a) Check the tires for wear and proper inflation pressure.
Standard cold tire inflation pressure:





*: Vehicle with off road package





(b) Using a dial indicator, check the tire runout.
Tire runout:
3.0 mm (0.118 in.) or less





2. ROTATE TIRE

HINT: Rotate the tires as shown in the illustration.

3. INSPECT WHEEL BALANCE





(a) Check and adjust the off-the-car balance.
(b) If necessary, check and adjust the on-the-car balance.
Standard imbalance after adjustment:
8 g (0.0180 lb) or less

NOTICE:
- Using a cleaning detergent, remove dirt, oil and water from the areas shown in the illustration. Approximately 25 mm (0.993 in.)





- Do not touch the adhesive part of the balance weight.
- Adhere the balance weight to the areas shown in the illustration.
- Push the balance weight securely with your fingers to attach it.
- Do not reuse the balance weight.

4. INSPECT FRONT AXLE HUB
(a) Inspect the front axle hub (Testing and Inspection).
5. INSPECT REAR AXLE SHAFT
(a) Inspect the rear axle shaft (Component Tests and General Diagnostics).