Removal

2UZ-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
- Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

2. DRAIN ENGINE COOLANT (Service and Repair)

3. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY (Removal)

4. REMOVE AIR CLEANER HOSE ASSEMBLY (Removal)

5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR





(a) Disconnect the connector.
(b) Remove the sensor and gasket.