Component Tests and General Diagnostics
SUPPLEMENTAL RESTRAINT SYSTEM: AIRBAG SYSTEM: Diagnosis Circuit
Diagnosis Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
- When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
- A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor. When all systems do not enter DTC output mode, there may be an ECM malfunction.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
- When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output (CAN Communication System).
Result
A -- REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
B -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)
(a) Turn the ignition switch OFF.
(b) Disconnect the A24 ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (ECM - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Result
B -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY
A -- REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
C -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY