Installation

A750E AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH:

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the switch to the manual valve shaft.

(b) Temporarily install the bolt.

(d) Temporarily install the control shaft lever RH.

(e) Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

(f) Align the groove with the neutral basic line.
(g) Hold the switch in position and tighten the bolt.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)

(h) Using a screwdriver, bend the tabs of the lock washer.

(i) Install the transmission control shaft lever RH with the spring washer and nut.
Torque: 16 Nm (163 kgf-cm, 12 ft-lbf)
(j) Connect the switch connector.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Connect the cable with the nut.
Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTE: When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

4. ADJUST SHIFT LEVER POSITION
(a) Adjust the shift lever position (Shift Lever Assembly (for Column Shift Type)).
5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Inspect the switch (On-Vehicle Inspection).