Installation

DIFFERENTIAL: DIFFERENTIAL CARRIER ASSEMBLY (for 1GR-FE, 2UZ-FE):

INSTALLATION

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY





(a) Clean the contact surfaces of the rear differential carrier and the rear axle housing.
(b) Install a new rear differential carrier gasket and the differential carrier with the 10 washers and 10 nuts.
Torque: 72 Nm (734 kgf-cm, 53 ft-lbf)

NOTE: Be careful not to damage the installation surface.

2. INSTALL REAR AXLE SHAFT LH
(a) Install the rear axle shaft LH (Installation).
3. INSTALL REAR AXLE SHAFT RH

HINT: Use the same procedures described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY
(a) Install the propeller shaft for 2WD (Service and Repair).
(b) Install the propeller shaft for 4WD (Service and Repair).
5. ADD DIFFERENTIAL OIL (Service and Repair)

6. INSTALL REAR WHEEL
(a) Install the rear wheels.
for aluminum wheel - Torque: 131 Nm (1336 kgf-cm, 97 ft-lbf)
for steel wheel - Torque: 209 Nm (2131 kgf-cm, 154 ft-lbf)